Step 1: The barcode printer cuts labels at the top, button or in the middle then CALIBRATION is needed.
Step 2: CALIBRATION OF ARGOX XSERIES PRINTER:
2.1Turn Off the Printer.
2.2Press and hold the PAUSE button and turn on the power.
2.3When “CALIBRATION ...” displayed on the LCD, and both READY and MEDIA indicators blink, release the PAUSE button.
2.4The printer feeds 12-inches of blank labels.
2.5When “READY” displayed, the READY and MEDIA indicators stop blinking but remain illuminated.
2.6You should repeat this procedure for up to 10 times.
Step 3: CALIBRATING ZEBRA PRINTER:
3.1Turn on the printer.
3.2Press and hold the FEED button until the green status light flashes once, then twice and then continuing until the flash groups reach the group of seven flashes. Release the FEED button.
3.3The printer will set the media sensor for the label used. After it is done making the adjustment, the roll will automatically feed until a label is positioned at the print head.
3.4Press the FEED button. One entire blank label will feed.
3.5You should repeat this procedure for up to 10 times.
#dolfin #pos #retail